The Prospector News

Osisko Development Intersects 19.81 g/t Au over 9.80 meters at Cariboo Gold Project, Shaft Zone

You have opened a direct link to the current edition PDF

Open PDF Close
Uncategorized

Share this news article

Osisko Development Intersects 19.81 g/t Au over 9.80 meters at Cariboo Gold Project, Shaft Zone

 

 

 

 

 

Osisko Development Corp. (TSX-V:ODV) is pleased to announce the remaining and final drilling results from the 2021 exploration and category conversion drill campaign of its Cariboo Gold Project in central British Columbia.

 

Summary

  • Results released below are from holes IM-21-155 to IM-21-203. Figures 1 and 2 illustrate drillhole location maps.
  • A total of 60,272 meters were drilled in 163 holes at the Shaft Zone on Island Mountain in 2021. A total of 10,355 m were drilled in 40 holes at Mosquito Creek on Island Mountain. The final Mosquito Results were reported in a news release on December 7, 2021.
  • All holes reported were collared on Shaft Zone, and six holes intersected the Valley Zone deposit at depth, on the east side of the Jack of Clubs fault. See Figure 2 for deposit outlines and Table 1 for detailed results.
  • Shaft Zone highlights include 19.81 g/t Au over 9.80 meters in hole IM-21-184 including a high grade sample of 193.00 g/t Au over 0.90 meter.
  • Drillhole IM-21-201, collared on Shaft Zone, but drilling through to Valley zone at a depth of 391 meters down hole (250 meters from surface) intersected a mineralized vein corridor at Valley that assayed 24.55 g/t Au over 9.65 meters including a high grade sample of 224.00 g/t Au over 0.55 meters.
  • Additional high grade samples include 101.00 g/t Au over 0.50 meter, 159.00 g/t Au over 0.55 meter, 105.00 g/t Au over 0.50 meter, 104.00 g/t Au over 0.50 meter, 130.00 g/t Au over 0.80 meter, 102.50 g/t Au over 0.55 meter and 187.00 g/t Au over 0.60 meter.
  • The drill results show continuity of vein corridors from Shaft Zone to Valley Zone along the south east of Shaft, at depth and down plunge into Valley Zone. The Shaft and Valley Zones are separated by the Jack of Clubs fault however mineralized vein corridors are continuous across the fault within the prospective sandstone unit.
  • Detailed drilling results and a drill hole location plan map are presented at the end of this release.

 

Assay Highlights

  • 85.35 g/t Au over 1.00 meter in hole IM-21-155 including
  • 101.00 g/t Au over 0.50 meter
  • 18.80 g/t Au over 6.70 meters in hole IM-21-159 including
  • 159.00 g/t Au over 0.55 meter
  • 39.87 g/t Au over 1.65 meters in hole IM-21-159 including
  • 53.50 g/t Au over 1.15 meters
  • 33.44 g/t Au over 2.10 meters in hole IM-21-161 including
  • 75.80 g/t Au over 0.90 meter
  • 10.22 g/t Au over 7.90 meters in hole IM-21-165
  • 12.35 g/t Au over 5.50 meters in hole IM-21-166 including
  • 105.00 g/t Au over 0.50 meter
  • 65.90 g/t Au over 0.90 meter in hole IM-21-166
  • 21.14 g/t Au over 5.70 meters in hole IM-21-170 including
  • 104.00 g/t Au over 0.50 meter
  • 37.76 g/t Au over 2.00 meters in hole IM-21-171 including
  • 91.20 g/t Au over 0.70 meter
  • 10.09 g/t Au over 5.00 meters in hole IM-21-171
  • 54.04 g/t Au over 1.25 meters in hole IM-21-174 including
  • 85.50 g/t Au over 0.75 meter
  • 12.93 g/t Au over 4.75 meters in hole IM-21-176
  • 14.10 g/t Au over 7.80 meters in hole IM-21-176
  • 23.61 g/t Au over 5.80 meters in hole IM-21-176 including
  • 130.00 g/t Au over 0.80 meter
  • 30.43 g/t Au over 2.05 meters in hole IM-21-178
  • 16.14 g/t Au over 3.35 meters in hole IM-21-181
  • 26.94 g/t Au over 2.40 meters in hole IM-21-182 including
  • 102.50 g/t Au over 0.55 meter
  • 19.81 g/t Au over 9.80 meters in hole IM-21-184 including
  • 193.00 g/t Au over 0.90 meter
  • 58.60 g/t Au over 1.00 meter in hole IM-21-185
  • 20.04 g/t Au over 4.75 meters in hole IM-21-190
  • 40.70 g/t Au over 1.50 meters in hole IM-21-191
  • 71.85 g/t Au over 2.05 meters in hole IM-21-192 including
  • 187.00 g/t Au over 0.60 meter
  • 24.55 g/t Au over 9.65 meters in hole IM-21-201 including
  • 224.00 g/t Au over 0.55 meter and
  • 68.90 g/t Au over 1.15 meters

 

Maggie Layman, Vice President of Exploration of Osisko Development commented: “We are pleased to report the remaining drill results from our 2021 exploration and category conversion drill campaign. The Shaft Zone and the Valley Zone are separated by the Jack of Clubs fault, a brittle fault structure striking north east and dipping approximately 50 degrees to the west. The 2021 drill campaign indicated vein corridors continuous on both sides of the fault and mineralized zones within the fault, indicating that the Shaft Zone vein corridors continue down plunge within the sandsone and are currently modelled to a depth of 560 meters from surface. The mineralized system remains open down plunge within the sandstone.”

 

Vein corridors are defined as high-density networks of mineralized quartz veins within the axis of the deposit’s last folding event. These mineralized structures are predominantly hosted within a brittle meta-sandstone or calcareous meta-sandstone. Vein corridors are modelled at a minimum thickness of 2.00 meters and average approximately 4.50 meters true width. Individual mineralized veins within these corridors have widths varying from centimeters to several meters and strike lengths from a few meters to over 50 meters. These corridors have been defined from surface to a vertical depth averaging 300 meters and remain open for expansion at depth and along strike. Gold grades are intimately associated with quartz vein-hosted pyrite as well as pyritic, intensely silicified wall rock vein selvages.

 

True widths are estimated to be 60% to 75 % of reported core length intervals. Intervals not recovered by drilling were assigned zero grade. Top cuts have not been applied to high grade assays. Complete assay highlights are presented in Table 1 and drill hole locations are listed in Table 2.

 

Figure 1: Cariboo Gold Project areas overview map (mineralized zones are shown in red) is available at

 

https://www.globenewswire.com/NewsRoom/AttachmentNg/18ec5342-8286-409a-bf9b-d67724c7a853

 

Figure 2: Shaft and Valley Zone select drilling highlights is available at

 

https://www.globenewswire.com/NewsRoom/AttachmentNg/80faba46-f82a-47aa-b69c-13aa30d32185

 

Qualified Persons

 

Per National Instrument 43-101 Standards of Disclosure for Mineral Projects, Maggie Layman, P.Geo. Vice President Exploration of Osisko Development Corp., is a Qualified Person and has prepared, validated, and approved the technical and scientific content of this news release.

 

Quality Assurance – Quality Control

 

Once received from the drill and processed, all drill core samples are sawn in half, labelled and bagged. The remaining drill core is subsequently stored on site at a secured facility in Wells, BC. Numbered security tags are applied to lab shipments for chain of custody requirements. Quality control samples are inserted at regular intervals in the sample stream, including blanks and reference materials with all sample shipments to monitor laboratory performance. The QAQC program was designed and approved by Lynda Bloom, P.Geo. of Analytical Solutions Ltd.

 

Drill core samples are submitted to ALS Geochemistry’s analytical facility in North Vancouver, British Columbia for preparation and analysis. The ALS facility is accredited to the ISO/IEC 17025 standard for gold assays and all analytical methods include quality control materials at set frequencies with established data acceptance criteria. The entire sample is crushed, and 250 grams is pulverized. Analysis for gold is by 50g fire assay fusion with atomic absorption (“AAS”) finish with a lower limit of 0.01 ppm and upper limit of 100 ppm. Samples with gold assays greater than 100 ppm are re-analyzed using a 1,000g screen metallic fire assay. A selected number of samples are also analyzed using a 48 multi-elemental geochemical package by a 4-acid digestion, followed by Inductively Coupled Plasma Atomic Emission Spectroscopy (“ICP-AES”) and Inductively Coupled Plasma Mass Spectroscopy (“ICP-MS”).

 

About Osisko Development Corp.

 

Osisko Development Corp. is uniquely positioned as a premier gold development company in North America to advance the Cariboo Gold Project and other properties in the USA and Mexico, with the objective of becoming the next mid-tier gold producer. The Cariboo Gold Project, located in central British Columbia, Canada, is Osisko Development’s flagship asset. The considerable exploration potential at depth and along strike distinguishes the Cariboo Gold Project relative to other development assets. Osisko Development’s project pipeline is complemented by its interest in the San Antonio gold project, located in Sonora, Mexico and the Trixie gold test mine, located in Utah, U.S.A.

 

Posted June 22, 2022

Share this news article

MORE or "UNCATEGORIZED"


Ascot Announces Closing of C$34 Million Bought Deal Financing

Ascot Resources Ltd. (TSX: AOT) (OTCQX: AOTVF) is pleased to anno... READ MORE

July 25, 2024

RUA GOLD Closes C$8 Million Brokered Offering and Announces Commencement of Trading on the TSX Venture Exchange

Highlights Closing the fully subscribed brokered offering for C$8... READ MORE

July 25, 2024

Mosaic Acquires 100% of the Amanda Project

Mosaic Minerals Corporation (CSE: MOC) announces that it has sign... READ MORE

July 25, 2024

First Phosphate Confirms Significant High-Quality Igneous Phosphate Deposit at Its Bégin-Lamarche Project in the Saguenay-Lac-St-Jean Region, Quebec au Canada

First Phosphate Corp. (CSE: PHOS) (OTC: FRSPF) (FSE: KD0) is ple... READ MORE

July 25, 2024

PROSPECT RIDGE ANNOUNCES FINAL CLOSING OF ITS OVERSUBSCRIBED PRIVATE PLACEMENT

Prospect Ridge Resources Corp.  (CSE: PRR) (OTC: PRRSF) (FRA: OE... READ MORE

July 25, 2024

Copyright 2024 The Prospector News