The Prospector News

P2 Gold Intersects 1.41 g/t Gold Equivalent Over 85.71 meters at Gabbs

You have opened a direct link to the current edition PDF

Open PDF Close
Uncategorized

Share this news article

P2 Gold Intersects 1.41 g/t Gold Equivalent Over 85.71 meters at Gabbs

 

 

 

 

 

P2 Gold Inc.  (TSX-V:PGLD) reports results from the final two diamond drill holes (GBD-003 and 004) of Phase One drilling at its Gabbs Project located on the Walker-Lane Trend in Nevada.

 

“Drill holes GBD-003 and 004 stepped out on either side of drill hole GBD-001 intersected the near-surface, higher-grade gold-copper domain identified in historical drilling at the Sullivan Zone. As with hole GBD-001, the intersection widths and grades exceeded our expectations,” commented Joe Ovsenek, President and CEO of P2. “The four diamond drill holes confirmed our thesis that the historical drilling understated the width and grade of the gold-copper mineralization at Gabbs. The recently completed reverse circulation drill program is expected to build on the diamond drill results.”

 

Select drill results (see Table 1 below for drill results) from holes GBD-003 and GBD-004 include:

  • Hole GBD-003 intersected 0.78 g/t gold equivalent (0.48 g/t gold and 0.26% copper) over 74.49 meters, including 15.24 meters grading 1.27/t gold equivalent (0.86 g/t gold and 0.36% copper); and
  • Hole GBD-004 intersected 1.41 g/t gold equivalent (1.00 g/t gold and 0.36% copper) over 85.71 meters, including 40.75 meters grading 2.14 g/t gold equivalent (1.56 g/t gold and 0.50% copper) and ended in mineralization.

 

Drill hole GBD-003 was drilled approximately 85 meters northwest of drill hole GBD-001, and drill hole GBD-004 was drilled approximately 95 meters southeast of drill hole GBD-001. Both GBD-003 and GBD-004 were diamond drill holes designed to test the full width of the Sullivan Zone and confirm the ore controls of the higher-grade gold–copper domain encountered by prior operators. Hole GBD-004 ended in mineralization due to mechanical issues with the drill.

 

Historically, drilling at the Sullivan Zone focused on the near-surface oxide gold mineralization, with a significant number of holes stopped in mineralization or not assayed for copper. The mineralization intersected in drill hole GBD-003 is approximately 40 meters thicker than defined by historical drilling and in drill hole GBD-004 is at least 60 meters thicker than defined by historical drilling. These intersections are at least 50% thicker than the historical intersections and at higher average grades. The high-grade mineralization is hosted by an intensely sericite altered monzonite, with the copper–gold mineralization extending well into the underlying chlorite altered pyroxenites.

 

A plan map and sections for drill holes GBD-003 and 004 of the Gabbs Phase One drill program are available here.

 

Table 1: Selected Gabbs Drill Results, October 2021 (GBD-003 and GBD-004)(1, 2)

 

Hole Collar Coords Dip/
Azimuth
From
(m)
To
(m)
Interval
(m)
Gold
(g/t)
Copper
(%)
AuEQ(3)
(g/t)
GBD-003 N4292711
E417542
-50/45 24.08 98.57 74.49 0.48 0.26 0.78
    Incl. 42.06 57.30 15.24 0.86 0.36 1.27
GBD-004 N4292586
E417663
-65/45 33.16 118.87 85.71 1.00 0.36 1.41
    Incl. 51.76 92.51 40.75 1.56 0.50 2.14

 

(1) True thickness to be determined.

(2) All samples were submitted for preparation by ALS Global at its facilities in Elko, Nevada, with the analysis completed at ALS Global facilities in Reno,

Nevada, and North Vancouver, British Columbia. All samples were analyzed using multi-digestion with ICP finish and fire assay with AA finish for gold. Samples with over 10 ppm gold were fire assayed with a gravimetric finish. One in 20 samples was blank, one in 20 was a standard sample, and one in 20 samples had a sample cut from assay rejects assayed as a field duplicate.

 

(3) Gold Equivalent calculations were consistent with the Gabbs Mineral Resource(1) which used US$1,600 per ounce gold, US$3.00 per pound copper, and copper recoveries of 90%.

 

Oxide mineralization was encountered down to approximately 120 meters in hole GBD-003 and the entire length of hole GBD-004. Recently completed metallurgical test work by P2 confirmed that the gold and copper mineralization yield relatively high recoveries for both heap leach and conventional milling options. The oxide copper was not included in the gold equivalent calculation for the Gabbs Mineral Resource(1) and as such represents a significant opportunity to increase the contained gold equivalent ounces.

 

Gabbs Phase One Drill Program

 

The reverse circulation drill program totaled 4,120 meters in 27 drill holes. The drill contractor has now demobilized from site due to other commitments. Assays for the reverse circulation drill holes will be released upon receipt.

 

Quality Assurance

 

Ken McNaughton, M.A.Sc., P.Eng., Chief Exploration Officer, P2 Gold, is the Qualified Person as defined by National Instrument 43-101, responsible for the Gabbs Project. Mr. McNaughton has reviewed, verified and approved the scientific and technical information in this news release.

 

___________________
1      See P2 Gold news release dated February 23, 2021 and Gabbs Project Technical Report filed on www.sedar.com on March 11, 2021.

 

About P2 Gold Inc.

 

P2 is a mineral exploration and development company focused on advancing precious metals and copper discoveries and acquisitions in the western United States and British Columbia.

 

Posted October 13, 2021

Share this news article

MORE or "UNCATEGORIZED"


Romios Gold Identifies Two New Folded Banded Iron Formations on the Lundmark-Akow Lake Project in NW Ontario

Romios Gold Resources Inc. (TSX-V:  RG) (OTCQB: RMIOF) (FSE: D4... READ MORE

October 18, 2021

Element 29 Drills 383.75 Metres of 0.71% CUEQ at the Elida Copper Project

Element 29 Resources Inc. (TSX-V: ECU) (OTCQB: EMTRF)  is please... READ MORE

October 18, 2021

Consolidated Uranium Announces Proposed Spin-Out of Labrador Uranium Inc., Creating a New Labrador Focused Uranium Explorer and Developer

Exercises Option on the Moran Lake Uranium and Vanadium Project L... READ MORE

October 18, 2021

Radisson reports high grade gold intercepts including 34.71 g/t Au over 3.90 m and 7.55 g/t Au over 10.50 m from resource expansion drilling along trend #1 at the O’Brien project

Radisson Mining Resources Inc. (TSX-V: RDS) (OTC: RMRDF):  is pl... READ MORE

October 18, 2021

Infill Drilling at O3 Mining's Marban Project Intersects 5.7 g/t Gold Over 14.5 Metres

O3 Mining Inc. (TSX-V: OIII) (OTCQX: OIIIF) is pleased to provid... READ MORE

October 18, 2021

We acknowledge the [financial] support of the Government of Canada.

Government of Canada Supported
Copyright 2021 The Prospector News