Emerita Resources Corp. (TSX – V: EMO) (OTC: EMOTF) announces that it has received assays for five additional drill holes from the Infanta drill program at the Iberia Belt West Project. In addition to the diamond drilling, the Company has received partial results from its ongoing geophysical program that are highly encouraging. The geophysical program has been suspended until after October 20, 2021 due to hunting season in the area.
Geophysical Survey – Progress report
Emerita has engaged the consulting firm, IGT, a specialized geophysical contractor based in Madrid, with broad international experience and a great deal of experience in the Iberian Belt in Spain and Portugal. The Geophysical survey carried out by IGT in 2013 in the vicinity of Aguas Teñidas mine was instrumental in the discovery of the Magdalena deposit, the most recent economic VMS deposit discovery in the Iberian Belt. The applied method was a combination of a gravimetry and Time Domain Electromagnetic (TEM) surveys. Emerita is using the same combination of surveys that led to the successful discovery of the Magdalena deposit.
The initial part of Emerita’s geophysical campaign consisted of the acquisition and interpretation of the gravimetric raw data, from previous surveys carried out by the Spanish Geological Service.
The gravimetric data shows two clear Bouguer anomalies separated by 800m to 1.0Km that run in parallel for about 7.0 Km in an East-West direction. The anomaly in the south is coincident with the mineralized horizon that hosts the Infanta Deposit and El Cura. The anomaly in the north has never been drilled. Both anomalies occur within the limits of the IBW exploration permit.
Figure 1: Bouger Gravity anomaly map Iberia Belt West Project. Note the northern anomaly trend that is believed to be a structural repetition of the Infanta mineralized horizon.
Follow up of the gravimetric anomalies is ongoing using TEM methods, using the TURAM mode (See Figure 2). The TEM method uses a large transmitter loop (fixed loop) which can allow detection up to 700 – 800 meters deep. The size of the loop is 2000 meters by 1000 meters. Surveying using a mobile loop configuration is also being employed where considered more appropriated than the fix loop. The lines are setup perpendicularly to the main mineralization trend. When completed, the survey is expected to comprise 41,000 meters of fixed loop and 10,000 meters of mobile loop data. To date, 40% and 60% of the measurement with the fixed loop and the mobile loop, respectively, have been completed. The program has been temporarily suspended to accommodate the hunting season in the area.
Numerous TEM anomalies over 150 Hz have been identified in the IBW project to date. From east to west, the first anomaly (1 on figure 2 below) is an 800 m long EW oriented conductor located near the eastern limit of the property and remains open to both ends. In the central area (2 on figure 2) a discrete anomaly is coincident with the mineralized lenses being drilled in La Infanta. This conductor continues to the west for more than 2.0Km and the conductive plate extends beyond 400 meters depth. A third conductor is coincident with the Bouguer gravity anomaly in the north (3 on figure 2) in an area that has never been drilled. Particularly intense is the anomaly detected in the western part of the IBW property, where the la Romanera deposit is located (4 on figure 2). These anomalies remain open along the east and west direction because the survey is not yet completed in this area. The area between Infanta and Romanera and to the west of Romanera are pending and will be completed after hunting season in October.
Figure 2: Geological map of the IBW project showing location of TEM conductors and completed survey (green) and planned survey lines (orange).
The work to date is greatly improving the Company’s geological understanding of the Project. A very important development is the recognition that the rocks are contained within structural blocks and that the mineralized horizon appears to have been repeated to the north of the Infanta deposit which essentially doubles the prospective stratigraphy in that area. This interpretation is supported by structural mapping and geophysical data as noted above. The orange coloured lines on Figure 2 in the center of the Project and at Romanera are planned but not yet surveyed, and will be completed following the hunting season. West of Infanta on the last line surveyed there is a one line strong conductor that appears to be the edge of the mineralized zone associate with El Cura. The small red polygon near Infanta illustrates the area where the Company is drill testing and shows that Emerita has only begun testing a very small portion of this Project.
Diamond Drilling Data
The Company has completed Phase 1 of the Infanta Drill program which was to verify the historical drilling for NI 43-101 purposes, provide fresh sample material that can be used for metallurgical testing and to verify the geological model. This phase comprised of 17 drill holes (assays pending for holes 14-17) and evaluated approximately 425 meters along strike and to a depth of 125 meters. Surface mapping of the deposit to date has been a very reliable indicator of mineralization at depth and surface mapping combined with geophysics suggests the strike length could be as much as 1.5 km for this deposit. Hole IN009 filled a 180 m gap between holes IN008 and 003 and demonstrates the mineralization is continuous along strike between these high grade intercepts. Hole IN010 is the deepest hole in the central part of the deposit demonstrating mineralization is open at depth in this area and hole IN013 is the furthest east and deepest hole in the explored area to date and intersected two lenses (see table below) and demonstrates continuity in that direction.
Phase 2 has commenced, whereby drilling is stepping out beyond the limits of the historical drilling, commenced with hole 18 and assays will be reported in the coming weeks. Hole 18 of Phase 2 intersected 8 meters of massive sulphides (assays pending).
Following is the complete data and drill hole locations for the diamond drill holes discussed above.
Table 1: Diamond drill hole assays, locations and orientions.
Figure 3: Location map for drill holes IN009-13.
Figure 4: Longitudinal section for drill holes IN009-13.
The scientific and technical information in this news release has been reviewed and approved by Mr. Joaquin Merino, P.Geo, President of the Company and a Qualified Person as defined by National Instrument 43-101 of the Canadian Securities Administrators.
About Emerita Resources Corp.
Emerita is a natural resource company engaged in the acquisition, exploration and development of mineral properties in Europe, with a primary focus on exploring in Spain. The Company’s corporate office and technical team are based in Sevilla, Spain with an administrative office in Toronto, Canada.
Drills 2.26 Metres at 11.81 gpt Gold And 39.31 gpt Silver within ... READ MORE
LAURION Mineral Exploration Inc. (TSXV: LME) (OTCPINK: LMEFF) is ... READ MORE
Astra Exploration Inc. (TSX-V: ASTR) is pleased to provide result... READ MORE
Osisko Mining Inc. (TSX:OSK) is pleased to provide new analytical... READ MORE
Drill results from Sullivan Gulch (located on the eastern portion... READ MORE
We acknowledge the [financial] support of the Government of Canada.