Summary of Results:
Two drill holes NT-110 and NT-111 were targeted on cross section 1700 (see cross section on company\’s website www.confederationmineralsltd.com). The holes were designed to test for continuity of high grade gold mineralization above hole NT-071 and NT-072 (see news release dated Sept 12, 2011) which intersected wide zones of gold mineralization with several greater than 10 g/t intercepts.
NT-111 intersects 13.0 metres of 5.71 g/t gold including two higher grade sections averaging 17.10 g/t gold over 1.0 metre and 49.60 g/t gold over 1.0 metre.
-- NT-111 intersects 45.0 metres of 1.21 g/t gold including 13.10 g/t gold over 1.0 metre -- NT-110 intersects 1.0 metre of 5.84 g/t gold
Discussion of Results:
Cross section 1700 now has four holes completed within the upper 200 metres of the Newman Todd Structure (\”NTS), at present there are several greater than 10 g/t gold intercepts on this cross section, which represents a 50 metre thick slice of the 1.8 km long NTS. The high grade is interpreted to occur within steeply plunging – northwest dipping silica-sulphide +/- magnetite replacement zones as shown on Cross section 1700. At present, these zones remain open along strike and at depth.
Lawrence Dick, CEO of Confederation states: \”Drilling on section 1700, which is one of our more detailed sections, clearly shows continuity of the gold mineralization between drill holes. It is our belief that with additional drilling this continuity of gold mineralization exists on every cross section throughout the Newman Todd Structure. For reference of scale, section 1700 represents a 50 metre thick slice through a 1.8 km long zone. The zone has been traced to a vertical depth of 600 metres and there is regional geological evidence that suggests it may be several kilometres deep. It is management\’s belief that this Red Lake type system will extend to significant depth. Deeper drilling is planned.\”
Table 1: Significant results -------------------------------------------------------------------------- From To Width(i) Gold Hole (m) (m) (m) (g/t) -------------------------------------------------------------------------- NT-110 29.00 30.00 1.00 2.20 -------------------------------------------------------------------------- NT-110 And 56.00 66.00 10.00 1.10 -------------------------------------------------------------------------- NT-110 Including 56.00 58.00 2.00 2.33 -------------------------------------------------------------------------- NT-110 and including 61.00 62.00 1.00 2.76 -------------------------------------------------------------------------- NT-110 And 84.00 89.00 5.00 2.23 -------------------------------------------------------------------------- NT-110 Including 85.00 86.00 1.00 5.84 -------------------------------------------------------------------------- NT-111 50.00 95.00 45.00 1.21 -------------------------------------------------------------------------- NT-111 Including 80.00 84.00 4.00 4.72 -------------------------------------------------------------------------- NT-111 and including 83.00 84.00 1.00 13.10 -------------------------------------------------------------------------- NT-111 And 140.00 141.00 1.00 16.50 -------------------------------------------------------------------------- NT-111 And 182.00 195.00 13.00 5.71 -------------------------------------------------------------------------- NT-111 Including 186.00 187.00 1.00 17.10 -------------------------------------------------------------------------- NT-111 and including 192.00 195.00 3.00 17.90 -------------------------------------------------------------------------- NT-111 and including 192.00 193.00 1.00 49.60 -------------------------------------------------------------------------- (i) Width is calculated as core length and does not imply true width of the zone. Weighted average gold intervals apply a 0.20 g/t lower cut-off. Internal dilution within reported intervals does not exceed core lengths of three metres unless otherwise indicated.
This phase of drilling will test several key geological and structural concepts identified in recent 3D modeling completed by the company. A successful drill program will assist with further targeting of discrete high grade structures along the entire strike length of the NTS. At present, the structure remains open both along strike, to surface and at depth.
Bob Singh P.Geo is the qualified person as defined by National Instrument 43-101 and has reviewed this news release. Mr. Singh has been engaged through a third party service provider by Confederation Minerals Ltd. to manage the project, and is also the Canadian Exploration Manager for Redstar Gold Corp.
Confederation Minerals Ltd. is a British Columbia based company engaged in the business of acquisition, exploration and development of mineral properties. Its objective is to locate and develop economic precious and base metals properties of merit. Confederation Minerals Ltd. holds an option agreement to acquire up to 70% of the Newman Todd project in the Red Lake Mining District of Northern Ontario as well as 100% ownership in two other properties in the Red Lake Mining District of Ontario.
Silver Mountain Resources Inc. (TSX-V: AGMR) (OTCQB: AGMRF) is ... READ MORE
Mandalay Resources Corporation (TSX: MND) (OTCQB: MNDJF) announce... READ MORE
Collective Mining Ltd. (TSX: CNL) (OTCQX: CNLMF) (FSE: GG1) is pl... READ MORE
Significant copper and molybdenum intersections include: HM19: 11... READ MORE
Red Pine Exploration Inc. (TSX-V: RPX) (OTCQB: RDEXF) is pleased ... READ MORE