The Prospector News

Caldas Gold Announces Latest Drilling Results Which Extend the Strike of the Recently Discovered New Zone to More Than 400 Meters at its Marmato Project, Colombia

You have opened a direct link to the current edition PDF

Open PDF Close
Uncategorized

Share this news article

Caldas Gold Announces Latest Drilling Results Which Extend the Strike of the Recently Discovered New Zone to More Than 400 Meters at its Marmato Project, Colombia

 

 

 

 

 

Caldas Gold Corp. (TSX-V: CGC) announced additional higher-grade gold intercepts over broad widths from the final ten diamond drill holes (7,120 meters) drilled in the Marmato Deeps Zone, completing the extension of the 2019 Phase 2 infill drilling program at its Marmato Project in Caldas, Colombia. This latest drilling, which was successful in extending the recently discovered New Zone along strike to more than 400 meters, was designed to test the strike extension of the NZ to the southeast and the down plunge extension of the Main Zone below the 600 meters level that was set as the bottom of the Indicated Resources for the upcoming pre-feasibility study, which is expected to be finalized in mid-2020.

 

High-grade mineralization over a broad width was also intercepted in hole MT-IU-062, representing a potential new zone south of the MDZ. This zone is anticipated to be accretive to overall global resource growth as the mineralization lies either outside the boundary of the current mineral resource estimate block model for the MZ or in areas that were previously estimated to be below the cut-off grade due to lack of information.

 

Serafino Iacono, Chairman and Interim Chief Executive Officer of Caldas Gold, commented, “Our enthusiasm continues to build as the NZ continues to deliver robust gold grades of a size that begins to resemble the MZ. The strike extension of more than 400 meters provides us with a high potential zone ready for infill drilling to continue to grow our world class deposit. In addition, the discovery of another potential new high-grade zone opens a new scenario for resource growth. All in all, we remain very encouraged by the potential for mineral resource growth in the MDZ at our Marmato Project.”

 

This extension phase of drilling started in late November 2019 and was completed in mid-March 2020 with two contractor diamond drill rigs operating from three purpose-built underground drill stations. It comprised a total of 10 drill holes totaling approximately 7,120 meters, of which 175 meters were drilled to deepen drill hole MT-IU-045 in order to fully intersect the NZ.

 

The Company plans to drill up to 10,000 meters of infill drilling on the NZ commencing near the end of May. This infill drilling is designed to convert Inferred mineral resources to the Indicated category and to add additional mineral resources by stepping out along the southeastern extension of the NZ.

 

Intersections with high gold grades generated from the last ten drill holes of the extension of Phase 2 drilling reported herein (MT-IU-045 and MT-IU-055A to MT-IU-064), include:

 

  • Drill hole MT-IU-056A intersected 68.90 m at 3.78 g/t Au and 1.4 g/t Ag from 562.50.75 m to 631.40 m, 24.25 m at 2.93 g/t Au and 1.5 g/t Ag from 653.75 m to 678.0 m, and 37.0 m at 2.94 g/t Au and 2.2 g/t Ag from 748.45 m to 885.45m; all these intersections are associated with the MZ.
  • Drill hole MT-IU-061 intersected 53.90 m at 3.23 g/t Au and 8.9 g/t Ag from 279.85 m to 333.75 m, and 36.35 m at 4.72 g/t Au and 25.0 g/t Ag from 527.45 m to 563.80, with the first intersection associated with the MZ and the second related to the NZ.
  • Drill hole MT-IU-062 intersected 44.40 m at 3.4 g/t Au and 3.8 g/t Ag from 423.20 m to 467.60 m on the NZ, 24.60 m at 2.99 g/t Au and 3.6 g/t Ag from 632.0 m to 656.60 m in the MZ, and 16.70 m at 2.87 g/t Au and 2.5 g/t Ag from 683.40 m to 700.0 m in the NZ-2.

 

The style of mineralization of the intersections associated with both the NZ and the NZ-2 is the same as the MZ and is characterized by very narrow veinlets of quartz-pyrrhotite-bismuth tellurides with free gold and minor amounts of pyrite and chalcopyrite, with a narrow halo of sodic-calcic alteration.

 

Key Highlights and Intercepts from the extension of Phase 2 drilling

 

  • The high-grade mineralization encountered so far that is associated with the NZ is currently interpreted to be related to a branch off the MZ that merges into the MZ to the northwest and runs subparallel to the MZ towards the southeast. Additional step-out drilling is currently being designed to test the potential extension of the NZ to the northwest;
  • The NZ extends more than 400 m along strike and 200 meters vertically, and it is still open to the southeast and at depth;
  • This new scenario gives to the Marmato Deeps Zone (MDZ) significant exploration upside that could lead to a large increase in the Resources and Reserves estimate.

 

The following table is a list of significant intersections from the ten drill holes (MT-IU-045 and MT-IU-055A to MT-IU-064) of the extension of Phase 2 drilling reported in this release:

 

 

Hole ID From (m) To (m) Width (m) Au Grade
(g/t)
Ag Grade
(g/t)
Grade-
Width
Zone
MT-IU-045 563.50 631.40 67.90 1.95 2.6 132.2 NZ
MT-IU-055A 307.25 686.00 378.75 1.97 1.5 745.2 MDZ
including 395.50 513.46 117.96 2.72 1.4 320.8 MZ
including 596.32 644.87 48.55 2.19 0.6 106.5 MZ
MT-IU-056A 496.55 785.45 288.90 2.45 1.8 708.6 MDZ
including 562.50 631.40 68.90 3.78 1.4 260.4 MZ
including 653.75 678.00 24.25 2.93 1.5 71.0 MZ
including 748.45 785.45 37.00 2.94 2.2 108.8 MZ
MT-IU-058 114.90 130.60 15.70 2.06 6.38 32.3 EVS
and 337.05 767.57 430.52 1.82 1.6 784.0 MDZ
including 337.05 380.90 43.85 2.48 3.6 108.9 MZ
including 489.60 511.85 22.25 2.34 1.7 52.0 MZ
including 535.80 609.00 73.20 2.44 1.5 179.0 MZ
including 735.72 767.57 31.85 3.24 2.5 103.2 MZ
MT-IU-059 NSI
MT-IU-060 381.62 771.15 389.53 1.87 2.9 729.9 MDZ
including 381.62 419.60 37.98 2.74 8.0 104.2 MZ
including 590.36 645.23 54.87 2.44 1.9 134.1 MZ
including 709.72 756.45 46.73 3.73 2.6 174.3 MZ
MT-IU-061 279.85 333.75 53.90 3.23 8.1 174.1 MZ
and 527.45 563.80 36.35 4.72 25.0 171.6 NZ
MT-IU-062 384.85 656.60 271.75 1.96 2.9 531.6 MDZ
including 423.20 467.60 44.40 3.40 3.8 151.1 NZ
including 632.00 656.60 24.60 2.99 3.6 73.5 MZ
and 683.40 700.10 16.70 2.87 2.5 48.0 NZ-2
MT-IU-063 335.20 472.60 137.40 2.07 4.4 284.6 MDZ
including 367.75 440.00 72.25 2.71 4.2 195.9 NZ
MT-IU-064 350.70 775.95 425.25 1.38 2.8 585.4 MDZ
including 452.35 489.40 37.05 2.23 2.8 82.6 MZ
including 560.77 579.05 18.28 2.30 6.8 42.0 MZ
including 632.20 661.40 29.20 2.24 2.3 65.5 MZ

 

Notes

  1. All holes are underground diamond drill holes. They were drilled at -63 to -80 degrees from the horizontal. The intersection lengths do not represent true widths.
    2. Sample lengths are on average 1.50 meters long but may be varied for geological and recovery factors.
    3. Intersections were calculated using a cut-off grade of 0.5 g/t gold, and no more than 5.0 m of continuous internal dilution for intervals up to 50 m, no more than 10 m of continuous internal dilution for intervals of 50-200 m, and no more than 20 m of continuous internal dilution for intervals greater than 201 m.
    4. Gold grades were capped at 13.0 g/t gold which affects 45 samples out of a total of 3273 samples.
    5. Intervals greater than or equal to 1.0 g/t Au are reported.
    6. NSI means no significant intervals.
    7. Grade-width is calculated as the width of the drill intersection in meters multiplied by the Au grade in g/t; the results may vary slightly from the product of the figures in the table due to rounding.
    8. Zone abbreviations: EVS – Epithermal Vein System, MZD – Marmato Deeps Zone, MZ – Main Zone, NZ – New Zone, NZ-2 – possible New Zone 2.
    9. The intersection in MT-IU-045 was previously reported to the end of the hole at 607.15 m (see press release of 15 November 2019). The hole was re-entered and deepened by 175.25 m to 782.40 m in order to fully intersect the NZ, and the extended intersection is reported here.
    10. Hole MT-IU-057 was lost when it intersected an old mine void.

 

Please refer also to the attached illustrative images in Attachment 1 showing a plan view of the NZ that occurs outside the current mineral resources model for the MZ and a cross-section for hole MT-IU-062.

 

Qualified Person

 

Dr. Stewart D. Redwood, PhD, FIMMM, Senior Consulting Geologist to the Company, is a qualified person as defined by National Instrument 43-101 – Standards of Disclosure or Mineral Projects and prepared or reviewed the preparation of the scientific and technical information in this press release. Verification included a review of the quality assurance and quality control samples, and review of the applicable assay databases and assay certificates.

 

Quality Assurance and Quality Control

 

The Marmato Project core samples were prepared by SGS Laboratories Ltd (ISO 9001:2008) at their laboratory in Medellin, and assayed in their laboratory in Lima, Peru. Gold was assayed by 30 g fire assay with atomic absorption spectrophotometer (“AAS”) finish. Samples over 10.0 g/t gold were re-assayed by 30 g fire assay with gravimetric finish. Silver was assayed by aqua regia digestion and AAS finish. Blank, standard and duplicate samples were routinely inserted for quality assurance and quality control.

 

About Caldas Gold Corp.

 

Caldas Gold is a Canadian junior mining company currently advancing a prefeasibility study for a major expansion and modernization of its underground mining operations at its Marmato Project in the Department of Caldas, Colombia with mineral resources of 2.0 million ounces of gold in the Measured and Indicated categories and 3.3 million ounces in the Inferred category. A Preliminary Economic Assessment study (Preliminary Economic Assessment Report, Marmato Project, Colombia, dated February 6, 2020 completed by SRK Consulting (U.S.), Inc.) is available on the Company’s SEDAR profile at www.sedar.com.

 

 

Attachment 1

 

Plan view showing the strike extension of the New Zone compared with the block model for gold: 

https://www.globenewswire.com/NewsRoom/AttachmentNg/682402fb-38bf-4705-9db9-eb26dad2969d

 

Cross-section showing the intersection associated with drill hole MT-IU-062 showing the potential New Zone 2 (NZ-2): 

https://www.globenewswire.com/NewsRoom/AttachmentNg/da28dcf0-3320-4dd3-9868-dfda45036f1d

 

Posted May 14, 2020

Share this news article

MORE or "UNCATEGORIZED"


VIZSLA SILVER AGREES TO ACQUIRE NEWLY CONSOLIDATED PAST-PRODUCING SILVER DISTRICT IN THE EMERGING SILVER-GOLD-RICH PANUCO - SAN DIMAS CORRIDOR IN MEXICO

Vizsla Silver Corp. (TSX-V: VZLA) (NYSE: VZLA) (Frankfurt: 0G3) i... READ MORE

March 28, 2024

Additional Drill Results Highlighted by Hole D-380 in Block 6 at Oko West, Intersecting 39.7 m Grading 5.27 g/t Au Including 2.8 m @ 14.18 g/t Au and 13.0 m Grading 10.50 g/t Au

Reunion Gold Corporation (TSX-V: RGD) (OTCQX: RGDFF) is pleased t... READ MORE

March 28, 2024

STLLR Gold’s Tower Gold Project Infill Drilling Continues to Confirm Mineralization at the Jonpol Deposit

STLLR Gold Inc. (TSX: STLR) (OTCQX: STLRF) (FSE: O9D) announces ... READ MORE

March 28, 2024

Hudbay Provides Annual Reserve and Resource Update and Production Outlook

Consolidated copper production is expected to average 153,000i to... READ MORE

March 28, 2024

Aya Gold & Silver: Record 2023 Production, Revenue and Operating Cash Flow

Aya Gold & Silver Inc. (TSX: AYA) (OTCQX: AYASF) is pleased t... READ MORE

March 28, 2024

Copyright 2024 The Prospector News